<strike id="imseu"></strike>

畜牧人

標題: 幫忙翻譯一個氟的檢測方法 [打印本頁]

作者: 叮當 時間: 2009-4-22 16:10
標題: 幫忙翻譯一個氟的檢測方法
11 F (Fluorine)

Substance	Fluorine
Type of method	see page 2
For investigation in	Animal feeds and animal feed raw materials N.B.: This method is not suitable for determining fluorine in mineral raw materials
Minimum determination limit	20 mg/kg
Repeatability	88 mg/kg at a level of 463 mg/kg (95% reliability interval, k=2)
Reproducibility	141 mg/kg at a level of 463 mg/kg (95% reliability interval, k=2)
Title	Determination of the fluorine content. Labco WVS-022.DOC version 6 July 2004

1. Definition
Determination of the fluorine content.
2. Intended area of use
The method is applicable to animal feed (raw materials).
3. Principle
The fluorine content is established with the assistance of an ion-selective electrode, after extraction with hydrochloric acid and deproteinisation with Carrez.
4. Reagents and requirements
All reagents and solvents must be of analysis quality, unless stated otherwise.
R1 Standard:
Titrisol fluoride: after topping up to 1 litre 1000 mg/l
R2 1M Hydrochloric acid:
132.3 ml hydrochloric acid (R12)
Demiwater up to 10000 ml
Shelf-life: _ years at room temperature
R3 3M Sodium acetate:
Dissolve 408 g sodium acetate (R13) in  900 ml of water.
Set the pH to 7.00  0.10 with acetic acid (R10) and top up to 1000 ml.
Shelf-life: 3 months at room temperature.
R4 Sodium citrate 1.32 M:
Dissolve 222 g sodium citrate (R14) in  250 ml of water.
Add 28 ml perchloric acid (R7) and top up to 1000 ml.
Shelf-life: 3 months at room temperature.
R5 Purification solution I (according to Carrez):
Potassium hexacyanoferrate II 265 g (R11)
Demiwater up to 2500 ml
Shelf-life: 3 months at room temperature.
R6 Purification solution II (according to Carrez):
Zinc acetate 547.5 g (R9)
Acetic acid 97% 75 ml (R10)
Demiwater up to 2500 ml
Shelf-life: 3 months at room temperature.
R7 Perchloric acid 70-72%
R8 Tisab III (total ionic strength adjustment buffer solution; e.g. Merck art. 1.16770, or equivalent)
R9 Zinc acetate dihydrate Zn(CH3COO)2.2H2O
R10 Glacial acetic acid 97%, CH3COOH
R11 Potassium hexacyanoferrate trihydrate K4[Fe(CN)6].3H2O
R12 Hydrochloric acid 24%
R13 Sodium acetate trihydrate
R14 Sodium citrate dihydrate
5. Equipment and resources
T1 500 ml plastic measuring flask
T2 Mixer/agitator
T3 Orion ion meter with:
- an ion-selective electrode for fluorine
- reference electrode
T4 Micropipettes, 1 ml and 5 ml
T5 pH meter
T6 Plastic beaker, 100 ml with stir bar
T7 Pipette, 25 ml
T8 Plastic beaker, 600 ml
T9 Plastic funnel
T10 Folded filter S&S 595 1/2
6. Sample pre-treatment
According to locally prevailing standard procedures
7. Method
7.1 Quality control
A control sample is taken for each series.
7.2 Weighing/extraction
Perform the analysis in duplo.
Weigh a quantity of sample material into a measuring flask (T1) of 500 ml in agreement with + 1000 μg fluorine (per 500 ml).
Add 50 ml hydrochloric acid 1M and stir for 60 minutes (R2, T2). Add 125 ml sodium acetate solution (R3) and 125 ml sodium citrate solution (R4) and mix. Add 5 ml Carrez I (R5) and agitate well. Then add 5 ml Carrez II (R6) and agitate well again. Top up to the line, mix and filter the sample (T8, T9, T10).
Pipette 25 ml into a 100 ml beaker (T6, T7) and add 2.5 ml Tisab (R8) (pH = 5.4 + 0.2).
Ascertain the concentration of fluorine by means of the standard addition method (R1) using an ion meter fitted with a fluoride electrode (T3, T4 and T5).
8. Calculation

c x V
F = ---------

g
where
F = Fluorine content, in mg/kg;
c = Concentration of fluorine present in the measured quantity sample, in μg/ml;
V = Conversion factor for the used dilution and quantity of the sample used for processing;
g = Weighed sample, in g.
9. Reporting
The outcome is reported as follows:
For a content less than the determinable limit:
Fluorine: less than 20 mg/kg
For a content equal to or greater than the determinable limit:
Fluorine: xxxx mg/kg
10. Characteristics
Demonstrable limit:
10 mg/kg
Determinable limit:
20 mg/kg
Repeatability:
88 mg/kg at a level of 463 mg/kg (95% reliability interval, k=2)
Reproducibility (in the laboratory):
141 mg/kg at a level of 463 mg/kg (95% reliability interval, k=2)
11. Quality control
The slope of the measurement must lie between 60 and 65.
12. Literature
AOAC Official Methods of Analyses 975.08. 15th edition 1990.
Fluorine in Animal Feed.

作者: bonderic 時間: 2009-4-25 20:27
看誰想練下翻譯水平又有時間的幫一下忙。版主有獎勵

作者: wxj1982 時間: 2009-4-26 10:22

氟的檢測

主題	氟
方法類型	見第2頁
檢測范圍	動物飼料和飼料原料 N.B.: 本方法不適于檢測礦物質原料中氟的含量
最低檢測限	20 mg/kg
重復性	88 mg/kg at a level of 463 mg/kg (95% 可信區間 k=2)
重現性	141 mg/kg at a level of 463 mg/kg (95% reliability interval, k=2)
標題	氟含量的檢測 Labco WVS-022.DOC 第6版 2004.7

1. 定義

氟的含量的測定
2使用范圍

本方法適用于動物飼料（原料）
3 原理

樣品經鹽酸溶液提取、卡瑞試劑去除蛋白后，利用離子選擇電極檢測其氟的含量
4. 試劑要求
除特殊要求外，所有試劑均為分析純
R1 標準品

滴定液;濃度1000mg/L，定容1L 。
R2 1M 鹽酸溶液：
132.3ml鹽酸（R12），用水定容到10000ml
保質期：室溫保存__ 年；
R3 3M 醋酸鈉溶液
溶解408g醋酸鈉(R13)于900 ml水中，用冰醋酸(R10) 調pH到7.00±0.10，定容到1000ml。
保質期: 室溫保存3個月；
R4 檸檬酸鈉溶液：1.32M
溶解222g檸檬酸(R14)于250ml水中，加入28ml高氯酸(R7),定容至1000ml。
保質期：室溫保存3個月；
R5 純化試劑I（據Carrez）

亞鐵氰化鉀(R11)265g，溶解并定容至2500ml。
保質期：室溫保存3個月
R6純化試劑II（據Carrez）
乙酸鋅547.5g (R9)
97% 冰醋酸 75ml(R10)
用水溶解并定容至2500ml。
保質期：室溫保存3個月

R7
0-72%高氯酸
R8 Tisab III (總離子強度校正緩沖溶液：
如：默克，產品號1.16770, 或相當產品)
R9 二水合醋酸鋅
Zn(CH3COO)2.2H2O
R10 冰醋酸 97%, CH3COOH
R11 三水合亞鐵氰化鉀 K4[Fe(CN)6].3H2O
R12 鹽酸 24%
R13 三水合乙酸鈉
R14 二水合檸檬酸鈉
5. 設備和材料
T1 500 ml 塑料量瓶

T2攪拌器
T3 離子計：帶有
氟離子選擇電極
參比電極
T4 微量移液管, 1 ml 和5 ml
T5 pH 計

T6 塑料燒杯t, 100 ml ，帶攪拌桿
T7 移液管, 25 ml
T8 塑料燒杯, 600 ml
T9 塑料漏斗
T10 折疊濾紙：S&S 595 1/2
6. 樣品前處理

依據當?shù)仄毡槭褂玫臉?biāo)準處理程序
7. 方法
7.1 質量控制
每組分析樣品必須帶有一個質控樣品
7.2 稱量/提取
以下分析請?jiān)谕L(fēng)廚內操作；
稱取一定量的樣品于500ml量瓶（T1）中，使氟的濃度在1000 μg（每500ml），加入50ml 1M鹽酸溶液，并攪拌60分鐘（R2, T2）；然后加入125ml醋酸鈉溶液(R3)和125ml檸檬酸鈉溶液(R4)，混合均勻；加入5ml 卡瑞試劑I并攪拌完全，再加入5ml 卡瑞試劑 II，再次攪拌完全，定容到刻度，混合均勻，過濾樣品(T8, T9, T10)。
移取25ml濾液到100ml燒杯中(T6, T7)，加入2.5ml Tisab試劑（R8）(pH = 5.4 + 0.2).
根據標準溶液加入法，利用帶有氟選擇電極的離子計，定量計算出氟的含量(T3, T4 和T5)。
8. 8 計算
c x V
F = ---------

g

式中：
F = 氟的含量，單位mg/kg;
c = 測試樣品中氟的濃度，單位μg/ml;
V = 樣品的稀釋倍數
g = 樣品質量，單位g
9. 報告

結果報告如下：

當含量低于檢測限時，F(xiàn) < 20mg/Kg

當含量等于或高于檢測限時，F(xiàn)：***mg/Kg

10-12 翻譯待斟酌，有不當之處請多指教

歡迎光臨畜牧人 (http://www.www12347.com/)

主站蜘蛛池模板：那曲县| 万源市| 蒙阴县| 杭锦旗| 绵阳市| 昌乐县| 宁都县| 全南县| 新丰县| 彰化县| 汾西县| 岳西县| 兴文县| 桓台县| 璧山县| 文山县| 渝中区| 汝南县| 富阳市| 云梦县| 离岛区| 开江县| 镇赉县| 乐至县| 科技| 富川| 丹阳市| 鸡东县| 连江县| 饶阳县| 呼伦贝尔市| 大冶市| 诸城市| 潞城市| 新宾| 邯郸市| 商洛市| 大渡口区| 宿州市| 安泽县| 芷江|